You will need a computer and an SD card to update the software on the Zmorph FAB machine.
Download the newest firmware from the bottom of this article.
Unzip the file.
Copy LCD folder and firmware.bin file to main directory of SD card.
Turn on the machine.
Insert SD card into the slot next to the LCD screen
Message about firmware update detection should appear and the 30 seconds countdown should start, after this time the update will begin automatically. Press 'Yes' to proceed. The machine will start updating the firmware. You shouldn't remove the SD card, turn off or reset the printer during this process.
After finished update the machine should restart itself.
Message about the screen update should appear. Press 'Yes'. The machine will start updating the LCD screens. You shouldn't remove the SD card, turn off or reset the printer during this process. This process may take up to 60 minutes.
After the successful update turn off and on the printer.
